REMOTE SETPOINT OPTION
Display Action Response
Press MENU
Press ENTER 		SET POINT
1) Press MENU, if necessary, until " Set Pt " prompt appears.
2) Display advances to " SP1 ", set point 1. PT
Press MENU IF THE REMOTE SETPOINT IS NOT INSTALLED, THE CONTROLLER WILL SHOW "NOT INSTALLED"
Press MENU, if you receive the "not installed"message.
Press ENTER
Press MAX & MIN
Press ENTER 		3) Display flashes 1st digit of previous selection for "Remote Setpoint 1" value.
4) Enter a new "remote setpoint 1" value.
5) Display flashes " strd " message and advances to "Remote Setpoint 2" submenu.
Press ENTER
Press MAX & MIN
Press ENTER 		3) Display flashes 1st digit of previous selection for "Remote Setpoint 2" value.
4) Enter a new "remote setpoint 2" value.
5) Display flashes " strd " message and advances to "Remote Setpoint 3 " submenu.
Press ENTER
Press MAX & MIN
Press ENTER		 REMOTE SETPOINT 3 SUBMENU:
3) Display flashes 1st digit of previous selection for "Remote Setpoint 3" value.
4) Enter a new "remote setpoint 3" value.
5) Display flashes " strd " message and and the display shows "reset" ending the Configuration Mode.
  RESET: The controller automatically resets after the last menu of the Configuration Mode has been entered. After the controller resets, the controller advances to the Run Mode (see Part 4 Operation: Run Mode).

Note: In order to select r.SP remotely connect Bi1 and Bi2 as follows:
Bi1
Bi2
r.SP.1
GND
GND
r.SP.2
GND
OPEN
r.SP.3
OPEN
GND
Set Point 1
OPEN
OPEN

Remote Setpoint Option
Flowchart 3.11 for Remote Setpoint
Figure 3.11 Flowchart for Remote Setpoint
Help Price List Specifications Print Manual Manuals Home
 Home Home  Table of Contents TOC  Back Back  Next Next